Day 2 - A Source Code File's Structure

What's Happening?

	Well, you white-belt NES programer you, today we're going to learn the structure
a NESASM code file. Unfortunately, our assembler is very finicky about the indentation of
our code. All labels start right at the begining of a line and everything else gets tabbed
in once. Even though this may sound bad, it really helps with readability and understanding
of the code, especially in big programs.

About Banks

	No, banks don't hold your money for you. They hold your program and all it's 
data. There are 3 banks that we will typically use, they are:

	Bank 0 - We're our code goes starting at $8000.

	Bank 1 - An Interrupt Table. Important. Starts at $FFFA for us.

	Bank 2 - Where we will be putting our sprite and background data.
		 Starting at $0000.

	I'm not sure how many banks there are, but it's obvious there's atleast 3.
We will use the .bank instruction to move banks. And we'll use .org to tell the 
assembler where we are starting from in that bank.

The INES Header

	The INES header comes at the beginning of every ROM file and tells the
emulator several things. The header pieces are:

	.inesprg     - tells how many program code banks there are.
	.ineschr     - tells how many picture data banks there are.
	.inesmir     - tells something I don't remember, but will be always 1.
	.inesmap     - We always use Mapper 0.

Our typical settings for these are:

	.inesprg 1   ; one (1) bank of program code
	.ineschr 1   ; one (1) bank of picture data
	.inesmap 0   ; we use mapper 0
	.inesmir 1   ; Mirror setting always 1.

Those four (4) lines will be at the (almost) very beginning of EVERY code file.

Bank 0 and .ORGing

	We will use Bank 0 to hold our code and start it at location $8000.
Here's how we'll do it:

	.bank 0   ; bank 0.
	.org $8000  ; goto location $8000.

	; program's code would go here.

That's all there is to that. Note that a semi-colon (;) means comment and the assembler
ignores anything past the semi-colon on the line.

Bank 1 And The 3 Interrupts

	Instead of a long paragraph, how 'bout some yummy code:

	.bank 1     ; change to bank 1
	.org $FFFA  ; start at $FFFA

	.dw 0        ; location of NMI Interrupt
	.dw Start    ; code to run at reset, we give address of Start label that
	; we will eventually put in bank 0
	.dw 0        ; location of VBlank Interrupt I think. either way, we don't need
	; it right now.

	Wasn't that easy, that's ALL that goes in bank 1, simple!

Bank 2 And Our Picture Data

	Bank 2, we will be starting at $0000 and in it we will include our picture data
for backgrounds and sprites. Here goes:

	.bank 2        ; change to bank 2
	.org $0000    ; start at $0000

	.incbin "our.bkg"  ; INClude BINary file that will contain our background pic
	; data.
	.incbin "our.spr"  ; INClude BINary file that will contain our sprite pic data

This Day In Review

	That's really all for today. I gotta go slow, as the NES is slightly more a
pain in the @$$ to program for than the GBA. Tomorrow, we will find out somemore stuff.
	
	See ya tomorrow!,
		-Mike H a.k.a GbaGuy

Intro - Day 3